Scarlett 6i6

Scarlett 6i6 Header

Articles

If you are running a Scarlett, Forte or iTrack Solo Interface on a Mac (no driver install needed) and it does not appear in the System Preferences at all you probably have the Novation USB Driver 2.3...
Previous issues with Pro Tools 11 and "Dynamic Plug-in Processing" have been resolved in updates to Pro Tools. Please make sure you have the latest version of Pro Tools 11 if this check box still...
Line inputs on Focusrite interfaces, both standard and combi, go through a small section of the preamp circuit. Due to the transparent nature of our preamps, however, this does not colour the signal...
Many of our interfaces come with an added feature called Standalone Mode. This enables the user to set these units up to work as an ADAT connected unit, similar to one of our Octopre MkIIs or any...
The Saffire and Scarlett microphone preamps provide between +10dB and +55dB of gain to the input signal before the converters. The gain required to obtain an acceptable signal level will depend on...
If you are seeing the following error message when trying to register your product, it may be possible that you have entered the 18 digit bundle-code instead. Please see the following short video for...
In the routing section of Saffire and Scarlett Mix control the term "Daw" in the drop down menu's refers to the outputs of the recording software that you are using. Normally by default a piece of...
This is because the interface's direct monitoring is enabled. This is the signal that goes direct from the interface's mic, line or inst input to the output without going through the computer so that...
Many new users become confused when they start recording and find that their Vocal or other signal from one microphone is placed only on the left in their headphones or speakers. The common question...
If you see the message "This version of Scarlett MixControl is out of date with respect to the connected device." when opening Scarlett MixControl on your Windows Computer, you'll need to install...
If you are having trouble with installing Plug Ins on a Mac please see this video . To get your Scarlett Plug Ins (or any other Focusrite or Novation Plug Ins) installed properly on your Windows...
Some users have reported experiencing audio glitches and drop outs with the Scarlett range of interfaces since updating to OS X 10.9 Mavericks. If you are experiencing these problems with your...
We have seen that Scarlett Mix Control can crash when using OS X 10.9 Mavericks. Our software team are currently working to investigate and fix the issue. We have found a workaround to the problem...
Many of our Setup Guides show you the preference menu of your DAW Software with a drop down menu that features the interface's name, Scarlett, Saffire, Forte, etc. On Mac the DAW will read the name...
If the locked (LKD on smaller interfaces) light on the front of your interface is off and it won't pass audio then the "Sync source" in Saffire/Scarlett MixControl is likely incorrectly set to a...
The Scarlett 6i6, 8i6, 18i6, and 18i8 use Focusrite PSU-05 (12V DC, 1250mA, center pin positive). If you need a replacement, please contact your local distributor (as found here ) about ordering.
The headphone outputs on the Scarlett 6i6 will contain a different signal, therefore whatever you assign to Monitor output 1 and 2 will go out of Headphone output 1 and whatever you assigne to Line...
The monitor pot on the Scarlett 18i8 does not control the level of the virtual monitor knob in MixControl. It is an analogue attenuator that controls the volume of the analogue signal going to the...