Dream Big with Focusrite - Win a dream recording weekend at Air Studios. Click here to enter

Rednet 4

8 Channel Mic Pre

Scarlett 2i4 Header

Articles

The No More Flows error in Dante Controller is commonly caused by people using Static IP Addresses and trying to route between Dante Virtual Soundcard and RedNet devices. It can also happen if you...
RedNet Control can do block routing based on the amount of Input/Output channels of a given device. This is great for quick routing, which is fine in most situations. But sometimes you may wish to...
If you find that you have no metering on the graphics in RedNet Control, then this is likely due to a FireWall on your system. You will need to add RedNet Control to the list of exceptions for your...
Currently, in order for Dante Virtual Soundcard to pass audio correctly a certain Dante Latency setting must be used in the Dante Virtual Soundcard settings. You must switch off Dante Virtual...
Dante makes use of standard Voice over IP (VoIP) protocols and utilises Quality of Service (QoS) switch features, to prioritize clock sync and audio traffic over other network traffic. VoIP QoS...
The Rednet 4's 8 input channels have both microphone inputs (on XLR connections) and line level inputs (on a single 25 pin connector adhering to the Tascam DB25 standard ). Inputs one and two also...
As well as the hardware controls on the front panel of the Rednet 4, the preamps can also be controlled remotely from the Rednet control software, allowing settings to be adjusted from across the...