iTrack Dock
Articles
The USB MIDI port on the iTrack Dock is for connecting class compliant USB MIDI controllers. Class compliant devices do not need a driver to be installed to work. A list of USB MIDI devices that we...
The iTrack Dock was designed to fit snugly with the iPad Air and iPad Mini 2 when using the Dock's slip mat - the dimensions of these iPads are what the hardware design of the Dock and slip mat were...
Direct monitoring allows a user to listen to the input signal of the interface with near zero latency. It takes the input signal on the interface and sends it straight to the headphone and line...
No, it is not possible to connect the iTrack Dock to either a mac or a pc system. It will only work with a compatible iPad. If you have any further questions please contact us here .
The iPad inherently heats up when being charged and the processor is being stressed, especially on the newer iPads with the more powerful processors. Both of these things happen when an iPad is use...
Ideally you should use the usb cable that comes with your midi device. The cable that is used to connect your midi device should be designed for data use and should not be a usb "charging" cable or...
If one of the Novation Launch products (Launchpad, Launch Control, Launchkey) is disconnected from the iTrack dock whilst it is connecting it may take up to a minute for it to connect again. To...
The iTrack Dock features a single USB MIDI port which will supply bus power to a connected device. Providing the MIDI device can be bus powered, then the iTrack Dock is capable of powering the device...
When the Launchpad Mini is running it full power mode it may fail to connect to the iTrack Dock straight away. To prevent this from happening either run the Launchpad Mini in low power mode or have...